Crestron Docking Station TPS-6X-DS Specifications download pdf (Page 17)

Crestron TPS-6X Series Isys 5.7” Wireless Touch Screens

Operations Guide – DOC. 6875C Isys 5.7” Wireless Touch Screens: TPS-6X Series • 13

If a project is running, the MAIN MENU can be accessed using one of two methods:

via the trigger keys on the top of the touch screen or via Crestron Toolbox.

Via the Trigger Keys

1. Press and hold the right trigger key on the top of the touch screen and at the

same time, touch the upper right corner of the screen.

2. Continue holding the right trigger key and touching the upper right corner

of the screen. At the same time, press and hold the left trigger key on the

top of the touch screen. After four seconds, the panel resets.

3. Once the screen turns black, release the left trigger key and the panel enters

the MAIN MENU, as shown in the illustration below.

4. Release the right trigger key and the touch screen.

Via Crestron Toolbox

1. Establish communication with the touch screen (refer to “Establishing

Communication” which starts on page 50 for details).

2. Right-click on the device and select Functions | Setup Mode….

3. Select Enter Setup Mode. The MAIN MENU is displayed, as shown in the

illustration below.

NOTE: Select Exit Setup Mode to exit the setup menu.

The MAIN MENU displays four large buttons: Touch Screen Calibration, Exit

and Run Program, Setup and Diagnostics, as shown in the following illustration.

MAIN MENU

The Exit and Run Program button verifies that all of the setup information has

been saved to the EEPROM and displays the main page that has been programmed

into the system. The remaining buttons on the MAIN MENU open other menus and

screens which are discussed in subsequent paragraphs.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 65 66

No comments

Crestron Docking Station TPS-6X-DS Specifications Page 17