Crestron C2ENET-2 Installation Guide download pdf (Page 10)

2-Series Ethernet Interface Expansion Cards Crestron C2ENET-1/-2

RACK2 Z-BUS Expansion Slot (Slot 1 shown) Example

3. Remove the Ethernet card from its packaging.

4. On the Ethernet card, make sure the thumbscrews are extended outward,

align the card with the card guides in the open Z-BUS expansion slot, and

slide the card into slot.

5. Firmly press both ends of the card faceplate to seat it on the Z-BUS

connector.

CAUTION: DO NOT FORCE CARD IN SLOT.

6. Tighten the thumbscrews to finger-tight to secure the card.

7. Reapply power and connect the Cresnet and Ethernet cables.

IP Setup

This section provides step-by-step instructions to configure a control system to

communicate over Ethernet using standard static IP configurations. The following

illustration shows a simplified example of a possible IP setup. The control system

and router are assigned IP numbers using Viewport. The external router is not

configured using Viewport.

IP Setup

Internet/

Intranet

DSL

Router

Hub

Control

System

C2ENET-1/-2

C2ENET1

C2ENET2

To/From

DSL Router via Hub

To/From

DSL Router via Hub

To/From

Crestron

IP Network

Static IP Number(s)

assigned in Viewport

Detail of C2ENET-1 and C2ENET-2

Ethernet configuration

To/From

Crestron

IP Network

(C2ENET-2)

Default

Router

6 • 2-Series Ethernet Interface Expansion Cards: C2ENET-1 & C2ENET-2 Operations & Installation Guide – DOC. 5962B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Crestron C2ENET-2 Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Networking Crestron C2ENET-2