Crestron CEN-NVS200 Installation Guide download pdf (Page 61)

Crestron CEN-NVS200 Network Video Streamer

Operations & Installation Guide – DOC. 7111E Network Video Streamer: CEN-NVS200

•

3. (Applicable only when PTZ Camera is selected) From the PTZ Driver:

drop-down list, select the desired PTZ driver. The CEN-NVS200 has five

built-in PTZ camera drivers: DynaDome/SmartDome, Pelco D, Pelco P,

LILIN and Samsung SCC-643.

NOTE: If PTZ camera functions do not operate, refer to the PTZ camera

documentation to verify that the camera supports those functions.

NOTE: If Custom camera is selected, pan, tilt, zoom and focus functions

must be configured by setting custom commands. Refer to “Setting Custom

Commands” which starts on page 59

for additional information.

4. (Applicable only when PTZ Camera or Transparent HTTP Tunnel is

selected) From the Port Settings: drop-down list, select the desired Baud

rate, Data bits, Stop bits and Parity bit.

5. Click Save.

To set preset positions and custom commands, refer to the sections that follow.

Setting Preset Positions

Configure preset positions by pressing the Preset Position button on the “Camera

Control” configuration page. The “Preset Position” configuration page opens.

“Preset Position” Page

To adjust presets, refer to the guidelines that follow.

NOTE: The CEN-NVS200 allows up to 20 preset locations.

Camera Control Area: In the camera control area, click one of the following

buttons to control PTZ camera functions:

• Left: Pans the camera to the left.

• Right: Pans the camera to the right.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

No comments

Crestron CEN-NVS200 Installation Guide Page 61