Crestron Multimedia Presentation System 300 MPS-300 User Manual download pdf (Page 2)

Crestron MPS-300 Multimedia Presentation System 300

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

Tel: 800.237.2041 / 201.767.3400

Fax: 201.767.1903

www.crestron.com

also provided for separate control of system power and projector power. In

addition, five preset buttons are included for custom functions such as lowering

a projection screen, closing blinds, or selecting a lighting preset.

The front panel label strips are easily customized using Crestron Engraver

software or standard 3/8” tape labels, allowing for the clear designation of each

input, output, and preset button. When selected, these functions will also appear

on the LCD display as generic names (Input 1, 2…), or as custom names (DVD,

Podium PC, Screen Up, etc.).

Easy setup of the MPS-300 is facilitated through the LCD display without

necessitating a computer. Together with 4 softkey buttons, 4 menu navigation

buttons and the volume knob, the LCD enables configuration of IP network,

audio, and other system settings. For security, the front panel controls can be

password protected or locked out.

2-Series Control System—Integrated into the MPS-300 is a Crestron 2-Series

Ethernet control system complete with e-Control

2 Web server and a host of

RS-232, IR, digital input and relay control ports for integration with third-party

equipment. Anything from a basic AV presentation room with a single projector,

screen, and keypad controller, to a fully custom touchpanel based system with

multiple controlled sources and display devices, can be programmed easily

using Crestron SystemBuilder™ software. And, the MPS-300 works with

Crestron RoomView

Help Desk software, the industry's most comprehensive

facility-wide asset management solution.

Room Control Options—Without requiring any programming, the MPS-300 can

be controlled simply using a Crestron APAD LCD Controller or a selection of

keypads. With custom programming, our complete line of Isys™ touchpanels

and MediaManager FlipTops is supported. Equipped with an optional

CNXRMIRD IR receiver, the MPS-300 allows any Crestron IR wireless touch-

panel or handheld remote to be used for a low-cost wireless control solution. Or,

adding an RF wireless gateway or Wi-Fi access point enables use of a wide

range of 1-way and 2-way RF wireless handheld remotes and touchpanels.

AVAILABLE MODELS

MPS-300

Multimedia Presentation System w/Stereo Amplifier

MPS-300-70V

Multimedia Presentation System w/70 Volt Amplifier

MPS-300-100V

Multimedia Presentation System w/100 Volt Amplifier

SPECIFICATIONS

Processor

CPU: 32-bit Freescale ColdFire

Microprocessor

Memory

32 MB SDRAM, 256 KB NVRAM, 16 MB Flash

Operating System

Real-time, preemptive, multitasking kernel, multi-threaded; FAT32 file system with long

names; supports SIMPL™ Windows

and SIMPL+

Ethernet

10/100BaseT, static IP or DHCP/DNS, SSL, auto-negotiating, full duplex TCP/IP, UDP/IP,

CIP, SMTP, SNMP, built-in Web server and e-mail client; supports Crestron e-Control

XPanel and RoomView

applications

Video

Switcher: 8x7 crosspoint matrix including 3x3 QM signal routing, local QM delay skew

compensation, RGB pass-thru mode (multi-format via RGB output connection)

Signal Types: RGB and composite, S-Video, or component video (does not transcode)

Video/HDTV Formats: NTSC or PAL, HDTV up to 1080i/1080p

RGB Formats: RGBHV, RGBS, RGsB

Maximum Resolution: 2048 X 1536 @ 60Hz (1920 X 1200 @ 60Hz via QM)

Blanking Time: < 0.1 second

Sync Rise/Fall Time: 3.5 ns maximum

Sync Latency: < 30 ns

Gain: 0dB (75 ohms terminated)

QM Cable Compensation: 10-bit digitally controlled PEAK (bandwidth) and BOOST (fre-

quency); 4-bit digitally controlled SKEW delay, 0 to 22 ns (independent for R, G, and B)

Audio

Switcher/Preamp: 8x4 stereo crosspoint matrix including 3x3 QM signal routing,

2-channel gated mic preamp with compressor & limiter, 8-channels mic EQ, 10X5

mic/program matrix mixer, 8x2 mic matrix mixer per each of 3 QM outputs, stereo

volume/tone control and EQ per each of PROGRAM and RECORD outputs, mono

volume/tone control and EQ/delay on SPEECH output, integrated power amplifier, QM

auto-compensation with self-peaking

A-D/D-A Conversion: 24-bit, 48 kHz

Volume Range: -80 to +20 dB, 0.1dB steps (output); -80 to 0 dB, 0.1dB steps (mixer)

Mute: -100dB (electronic), -120dB (relay)

Input Compensation: ±10dB, 0.1dB steps

Mic Input Gain: 0 to 100 % (40dB range) plus mute

Gate Level (Threshold): 0 to 100 %

Gate Attack: 0 to 100 mS

Gate Decay (Release): 0 to 5000 mS

Gate Depth: -80dB (mute) to 0dB, 0.1dB steps

Compression Threshold: -80dB to +20dB, 0.1dB steps

Limit Threshold: 0dB to 20dB, 0.1dB steps

Comp/Lim Attack: Separately adjustable 0.1 to 300 mS

Comp/Lim Release: Separately adjustable 1 to 500 mS

Compression Ratio: 1.0:1 to 10.0:1

Comp/Lim Curve: Separately selectable hard or soft knee

Mic EQ: ±12dB, 0.1 dB steps at 160, 500, 1.2k, and 3k Hz

Bass/Treble: ±12dB, 0.5dB steps at 100Hz and 10kHz

Output Equalization: 10-band graphic (GEQ) + 2-band parametric (PEQ)

GEQ: ±12dB, 0.1dB steps at 31, 63, 125, 250, 500, 1k, 2k, 4k, 8k, and 16k Hz

PEQ Filter Gain/Center Frequency: ±12dB, 0.1dB steps at 25Hz to 20kHz, 0.5Hz steps

PEQ Filter Bandwidth: 0.1 to 3.0 octaves, 0.1 octave steps

PEQ Filter Types: Low Pass, High Pass, Peaking Eq, Notch, Treble Shelf, Bass Shelf

Speech Output Delay: 0 to 40 mS, 1mS steps

Frequency Response: 20Hz to 20kHz ±0.5dB (PROG/REC OUT), 50Hz to 20kHz ±0.5dB

(SPEECH OUT), 20Hz to 20kHz ±0.5dB (SPEAKER @ 8 ohms), 100Hz to 20kHz ±1.5dB

(SPEAKER @ 70V or 100V)

S/N Ratio: 95dB (PROG/REC OUT @ 10dBV, 20Hz to 20kHz A-weighted), 95dB (SPEECH

OUT @ 10dBV, 50Hz to 20kHz A-weighted), 90dB (SPEAKER @ 8 ohms, full output,

20Hz to 20kHz A-weighted), 90dB (SPEAKER @ 70V or 100V, full output, 20Hz to 20kHz

A-weighted)

THD+N: 0.02% (PROG/REC OUT @ 10dBV, 20Hz to 20kHz), 0.02% (SPEECH OUT

@ 10dBV, 50Hz to 20kHz), 0.7% (SPEAKER @ 8 ohms, full output, 20Hz to 20kHz),

0.7% (SPEAKER @ 70V or 100V, full output, 100Hz to 20kHz A-weighted)

Stereo Separation: -80dB (PROG/REC OUT @ 10dBV, 20Hz to 20kHz), -60dB (SPEAKER

@ 8 ohms, full output, 20Hz to 20kHz)

Channel Crosstalk: -80dB (AUD IN @ 10dBV, 20Hz to 20kHz)

1 2 3 4

Comments to this Manuals

No comments

Crestron Multimedia Presentation System 300 MPS-300 User Manual Page 2

Comments to this Manuals

Related products and manuals for Networking Crestron Multimedia Presentation System 300 MPS-300