Crestron TPS-3000 Specifications download pdf (Page 9)

Crestron TPS-IMPC Interface Module

CAUTION: The 10-pin RJ-45 net/video connector cable supplied by

Crestron is a custom cable and is the only one that should be used. The

end of the cable has a metal shield that is required to protect the

equipment. Using non-Crestron cables will result in damage to the

product.

AUDIO (To Panel)

AUDIO

This 8-pin RJ-45 mates with the TPS-3000, TPS-5000, or TPS-6000

touchpanel. The 8-pin audio cable assembly is supplied. Even though the

10-pin net/video cable may fit into the port, do not use it. This port

provides audio input to the touchpanel and microphone output from the

touchpanel. A description of the pinouts is shown in the following table.

AUDIO Pinouts

TYPE PIN DESIGNATION DESCRIPTION

1 L+ Left Input (Positive)

2 L- Left Input (Negative)

3 GND/Shield Audio Input Ground/Shield

4 R+ Right Input (Positive)

5 R- Right Input (Negative)

6 GND/Shield Mic Output Ground/Shield

7 M+ Mic Output (Positive)

Front

Top

8 M- Mic Output (Negative)

To determine the location of pin 1, hold the cable so that the end of the

8-pin RJ-45 connector is facing away from you, with the clip side down

and the copper side up. The copper connector on the far left is pin 1.

AUDIO INPUT

The port mates with a six-pin connector (supplied) and provides balanced

and/or unbalanced audio input. Description of the pinouts is shown in the

following table.

Operations Guide - DOC. 6162 Interface Module: TPS-IMPC • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Crestron TPS-3000 Specifications Page 9