Crestron SIRIUSSatellite Radio User Manual download pdf (Page 3)

sirius_radio_control_v1 ControlWorks Consulting, LLC

Telephone: (+1)440-449-1100 [email protected] http://www.controlworks.com

Module Application

This module allows a Crestron 2-Series processor to control a Sirius satellite radio tuner via

RS-232. A Sirius SCH1P2 & SCH2P tuner was used to develop this module, but the module

should be compatible with the Sirius SCHDOC1 as well (with compatible dock n play and

portable radios).

The module has also been tested against the Polk SRH1000, and ADA SRX and was found to

control them correctly only if they were put into pass-through or installer mode. This mode

is not a stable mode in either receiver as power-cycling the receiver will drop it back into

normal operation mode and thus defeat control.

By default, the Sirius tuners are setup to send unsolicited updates of program data upon a

channel change or a song change.

The allow_skipped and allow_locked inputs will only have an effect on the direct tuning

keypad of the module. Channel, Category, and Program up/down commands will always

bypass skipped or locked channels.

The press-and-hold presets store the name and channel number in the processor's NVRAM.

Upon first loading the program, you may have gibberish on the preset buttons. To resolve

this, you can press-and-hold to store a preset in each location. Alternately, you can erase the

NVRAM of you processor by typing "nvramclear" at the command prompt in Viewport or

Toolbox. This will erase all NVRAM in your program, not just the presets. If you have other

information stored in the NVRAM, it will be lost.

1 2 3 4 5 6 7 8

No comments

Crestron SIRIUSSatellite Radio User Manual Page 3