Crestron CNAMPX-2X60 Specifications download pdf (Page 9)

Crestron

CNAMPX-2X60

2 Channel Professional Audio Amplifier

CNAMPX-2X60 Front Panel Power Switch

As shown below, the front panel of the CNAMPX-2X60 contains a power switch

with an LED indicator. This two-position (ON/OFF) switch enables operating power

to the CNAMPX-2X60 circuitry. It must be positioned to ON when the unit is to be

controlled by the control system. When the Cresnet system 24VDC is applied to the

NET connector on the rear panel and the switch is set to ON, AC power is applied to

the unit and the LED (green) illuminates.

CNAMPX-2X60 Front Panel

CNAMPX-2X60

POWER

P R O F E S S I O N A L A U D I O A M P L I F I E R

2 C H A N N E L 6 0 W A T T

CRESTRON

Leading Specifications

The table below and continued on the next page provides a summary of leading

specifications for the CNAMPX-2X60.

Leading Specifications of the CNAMPX-2X60

SPECIFICATION DETAILS

Power Input Requirements: US version 120VAC +/-10%, 50-60Hz, 960 Watts

International version 230VAC +/-10%, 50-60Hz, 960 Watts

Cresnet Power Requirements 3 Watts (24VDC @ 0.125A)

Default NET ID 3F

Channels 2 Unbridged; 1 Bridged

60 Watts/Channel

into 8-ohm loads

90 Watts/Channel

into 4-ohm loads

200 Watts/Channel Bridged into 8-ohms

Input Impedance 28Kohms

Power Bandwidth - 3dB 3Hz to 50KHz

Frequency Response @ 1W 8ohm Flat +0, -0.1dB from 20Hz to 20KHz

THD @ full power

0.03% or less

SMPTE I.M. Distortion

0.03% or less

Signal to Noise Ratio (S/N) "A" Weighted >110dB

Gain 28dB

Damping Factor >400

Channel Separation over full bandwidth >100dB

Output Power - All channels driven,

20Hz to 20KHz, at rated Total Harmonic

Distortion (THD).

Operations Guide – DOC. 8178 2 Channel Professional Audio Amplifier: CNAMPX-2X60 • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Crestron CNAMPX-2X60 Specifications Page 9

Comments to this Manuals

Related products and manuals for Audio amplifiers Crestron CNAMPX-2X60