Crestron C2N-IRGW-F Installation Guide download pdf (Page 12)

IR Gateway Crestron C2N-IRGW-F

The following tools/hardware are required for installation of a

C2N-IRGW-F.

• Cresnet network cable (not supplied)

• Four wire nuts to connect Cresnet wires (supplied)

• Drill, hole saw or other means to cut hole in wall or ceiling tile

After the Cresnet network wiring has been installed and verified, use the

following procedure to install the C2N-IRGW-F (refer to illustration that

follows this paragraph):

1. Turn Cresnet system power OFF.

2. Locate an area on the wall or ceiling that is free of miscellaneous

wiring and studs. Make a small hole near the center of the

designated mounting location to verify that the location is suitable.

3. Drill or cut a 1-inch (2.54 cm) diameter circular hole in the wall or

ceiling at the desired location.

4. Route the Cresnet wires from the control system to the

C2N-IRGW-F location.

5. Use the four supplied wire nuts to connect the wires (red to red,

white to white, blue to blue and black to black) to the

C2N-IRGW-F’s pigtail wires.

6. Press fit the C2N-IRGW-F into the hole; the mounting clips on

either side of the C2N-IRGW-F hold it in place.

C2N-IRGW-F Installation view

Pigtail Wires from C2N-IRGW-F

1 in (2.54 cm) Hole

Mounting Clips

Cresnet Wires

Wire Nuts

8 • IR Gateway: C2N-IRGW-F Operations & Installation Guide – DOC. 6574A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Crestron C2N-IRGW-F Installation Guide Page 12