Crestron TPMC-4X Specifications download pdf (Page 15)

Crestron TPMC-4X Isys i/O

™

Handheld WiFi Touchpanel

Setup

Identity Code

The IP ID is set within the TPMC-4X’s table using Crestron Toolbox or during

configuration of the unit in the Setup pages of the TPMC-4X. For information on

setting an IP table, refer to the Crestron Toolbox help file.

The IP IDs of multiple TPMC-4X devices in the same system must be unique. When

setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the SIMPL

Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Power

The TPMC-4X is powered via its internal battery. Connect the supplied power

supply to the TPMC-4X-DS docking station.

NOTE: Before using the TPMC-4X for the first time, charge its internal battery for

at least eight hours by placing it in the TPMC-4X-DS docking station.

It takes the TPMC-4X about eight hours to recharge while in use. A fully charged

battery can provide up to three hours of use at the full screen brightness setting.

The battery recharge capacity is 500 cycles to 80% of original capacity.

NOTE: When not using the TPMC-4X, store the unit in its docking station.

Configuring the Touchpanel

When power is applied to the unit for the first time, the following screen appears.

Initial Opening Screen

Operations Guide – DOC. 6499 Isys i/O

™

Handheld WiFi Touchpanel: TPMC-4X • 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

Crestron TPMC-4X Specifications Page 15