Crestron CHV-RTHS User Manual download pdf (Page 9)

Crestron CHV-RTS/CHV-RTHS Remote Temperature/Humidity Sensors

Pigtail Wires from Sensor

1in (2.54cm) Hole

Mounting Clips

Wires from Thermostat

Wire Nuts

NOTE: The face of the sensor may be painted or wallpapered to match

the wall. However, keep the small gap around the outer edge clear of any

obstructions.

Hardware Hookup

The sensors are connected to the terminal blocks on the rear plastic

housing of the thermostat. Separate the thermostat from its backplate. The

thermostat terminal blocks mate to pins protruding out of the front

thermostat assembly.

NOTE: The current firmware release supports the addition of only two

optional remote sensors (temperature and/or temperature/humidity) per

thermostat. Future firmware releases will support up to four optional

temperature or temperature/humidity sensors, in any combination.

Installation Guide - DOC. 8189 Remote Temperature/Humidity Sensors • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Crestron CHV-RTHS User Manual Page 9