Crestron STRFGWX Specifications download pdf (Page 13)

Crestron STX-1550C 2-Way RF Compact Color Touchpanel

RF Settings Screen

NOTE: Do not set the RF ID to “0”; it is not supported in SIMPL Windows.

The RF SETTINGS button opens the RF SETTINGS screen, shown to the left. The

RF ID is displayed in the RF SETTINGS screen. The RF ID must match the identity

code in the SIMPL Windows program and is identified by a hexadecimal number in

the range from 0 to F. In the diagram, the RF ID is shown with a setting of “01”. The

DOWN and UP buttons associated with the RF ID field decrease and increase the RF

ID by one, respectively.

NOTE: Due to network traffic, the STX-1550C may not respond to a network

upload. To compensate, access the setup screens (refer to “Configuring the

Touchpanel” on page 6) to provide exclusive upload communication between the

touchpanel and the control system.

The RF CHANNEL of the touchpanel

must be identical to the RF

CHANNEL of the STRFGWX(s) to

which it communicates. The same

channel may be used for more than

one STRFGWX when used to expand

the roaming capabilities of a

touchpanel within any particular

area(s) or installation.

The RF CHANNEL is displayed in the RF SETTINGS screen. The RF CHANNEL

is identified by a hexadecimal number in the range from 0 to F. In the diagram, the

RF CHANNEL is shown with a setting of “F”. The DOWN and UP buttons

associated with the RF ID field decrease and increase the RF ID by one,

respectively.

The TEST button should only be used under supervision from a Crestron customer

service representative during telephone support. The options available from the

TEST Menu are beyond the scope of this guide.

Select the RETURN button after interface parameters have been set.

Sound Screen

Sound Submenu

The SOUND button, located at the top right corner of the Setup Menu, is used to

display the Sound Menu, shown to the left. Use this screen to activate audible key

clicks. This feature is a useful feedback tool. Confirmation of a button press on a

touchpanel is acknowledged by an audible click assuming this feature is enabled. To

enable this feature, verify that the KEYCLICK ON button is active (red). An active

KEYCLICK OFF button disables the feature. Volume of the audible click is

controlled with the VOLUME UP and VOLUME DOWN buttons. The unit is

factory set with the sound on.

Uploading and Upgrading

To upload a VT Pro-e project or upgrade the firmware of the STX-1550C, a local PC

that contains the Crestron Viewport (available in SIMPL Windows or VT Pro-e) is

required. Refer to the following sections.

Hookup and Preparation

To prepare the STX-1550C for uploading or upgrading, refer to the figures shown on

the next page for typical connection diagrams. Complete the following steps

provided to ensure proper connection to the system.

NOTE: The components in the second figure on the next page are part of the

SmarTouch Programming Kit (ST-PK). If available, use these components.

Operations Guide - DOC. 5812A 2-Way RF Compact Color Touchpanel: STX-1550C • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments

Crestron STRFGWX Specifications Page 13

Comments to this Manuals

Related products and manuals for Mobile device dock stations Crestron STRFGWX