Crestron C2N-RTHS Installation Guide download pdf (Page 10)

Temperature and Humidity Sensor, Cresnet

Crestron C2N-RTHS

Installation

NOTE: Ensure the location is not close to a heat or humidity source and

is away from direct sunlight, skylights, and windows. When mounting the

sensor outdoors, do not place in direct sunlight, and do not place where

the sensor will be directly exposed to precipitation. Sensors are suitable

for mounting in dry or damp locations as defined by the National

Electrical Code.

Complete the following procedure to install the C2N-RTHS:

1. Locate an area on the wall that is free of miscellaneous wiring and

studs.

2. Make a small hole near the center of the designated mounting site

to verify that the location is suitable.

3. Drill or cut a 1 in (26 mm) diameter circular hole in the wall at the

desired position.

4. Route the Cresnet wires to the sensor. Use the four wire nuts

included to connect the wires (red to red, white to white, blue to

blue, and black to black).

Cresnet Wiring for the C2N-RTHS

Red 24V

White Y

Blue Z

Black Ground

5. Press fit the sensor into the hole; the clips on either side of the

sensor hold it in place.

NOTE: The face of the sensor may be painted or wallpapered to match

the wall. Ensure that paint does not enter (or wall paper cover) the

perimeter gap or the holes for the Setup button and LED.

6 • Sensor, Cresnet

Operations and Installation Guide - DOC. 6232B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Crestron C2N-RTHS Installation Guide Page 10