Crestron QM-FTDC Installation Guide download pdf (Page 23)

Crestron QM-FTDC FlipTop Data Center

Button Installation

QM-FTCMK Cable Management Plate

The QM-FTDC is shipped with a blank bottom plate. A cable management plate is

available to provide a pullout cable solution for the computer input and LAN pass-

through cables. The kit contains two 6-foot cables (computer and computer audio).

• Order the QM-FTCMK Cable Management Kit for domestic models.

• Order the QMI-FTCMK Cable Management Kit for international models.

Parts Supplied with Optional Cable Management Kit

PART DESCRIPTION QUANTITY

Small Cable Bushing, 5/16 inch ID, 0.5 inch OD 4

Large cable Bushing, 0.55 inch ID, 0.80 inch OD 2

Cable Support Plate 1

Tie Wrap 3

Computer RGB Cable, VGA to VGA, 6 ft long 1

Computer Audio Cable, 3.5 mm Stereo, 6 ft long 1

Tools required:

• Phillips screwdriver

• Small flat-blade screwdriver (for connecting the VGA cable)

The cable support plate must be installed before mounting the QM-FTDC to a

surface. The cables are looped through the cable support plate.

1. Remove the blank bottom plate and retain the four #4 x ¼ LG black

mounting screws (the QMI-FTCMK includes four #4 x ¼ screws).

2. Place the bushings on the cables (six bushings supplied). Use the large

bushing for the VGA cable.

3. Thread the cables through the appropriate slot on the plate.

4. Snap the bushings into the plate slots.

Operations & Installation Guide – DOC. 6312B FlipTop Data Center: QM-FTDC • 19

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

No comments

Crestron QM-FTDC Installation Guide Page 23