Crestron TPS-3000 Specifications download pdf (Page 13)

Crestron Isys

TPS-3000 6.4 Inch Tilt Touchpanel

Industry Compliance

As of the date of manufacture, the TPS-3000 has been tested and found to comply

with specifications for CE marking and standards per EMC and

Radiocommunications Compliance Labelling.

NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Setup

Network Wiring

CAUTION: In order to ensure optimum performance over the full range of your

installation topology, Crestron Certified Wire, and only Crestron Certified Wire,

should be used. Failure to do so, may incur additional charges if support is required

to identify performance deficiencies as a result of using improper wire.

CAUTION: Provide sufficient power to the system. Insufficient power can lead to

unpredictable results or damage to the equipment. Please use the Crestron Power

Calculator to help calculate how much power is needed for the system

(http://www.crestron.com/calculators).

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to

do so could cause equipment damage or void the Crestron warranty.

NOTE: When installing network wiring, refer to the latest revision of the wiring

diagram(s) appropriate for your specific system configuration, available from the

Crestron website.

When calculating the wire gauge for a particular Cresnet

run, the length of the run

and the Cresnet power usage of each network unit to be connected must be taken into

consideration. If Cresnet units are to be daisy-chained on the run, the Cresnet power

usage of each unit to be daisy-chained must be added together to determine the

Cresnet power usage of the entire chain. If the unit is a home-run from a Crestron

system power supply network port, the Cresnet power usage of that unit is the

Cresnet power usage of the entire run. The length of the run in feet and the Cresnet

power usage of the run should be used in the resistance equation below to calculate

the value on the right side of the equation.

Resistance Equation

Operations Guide – DOC. 6076A 6.4 Inch Tilt Touchpanel: Crestron Isys

TPS-3000 • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

No comments

Crestron TPS-3000 Specifications Page 13