Crestron CNX-PAD8 Specifications download pdf (Page 8)

Professional Audio Distribution Processor Crestron CNX-PAD8A

CNX-PAD8A Ports

A number of ports are provided on the back of the CNX-PAD8A. Each has a silk-

screened label. Refer to the illustration and descriptions below.

CNX-PAD8A Ports

USA07647.J.NROC K LEIGH,INC .ELECT RO INCS

CR SETRON

NET

NOTE: There are no RJ-11 connectors on this product.

Use the supplied 4-pin network connector as described in "Network Wiring" on page

9 and connect the control system and other peripherals to this port.

(Chassis Ground)

Use this chassis screw to connect the audio source(s) common ground(s) to the

CNX-PAD8A.

SOURCES 1 - 8

Each of the eight sets of four RCA connectors is used to connect the independent

audio sources to the CNX-PAD8A. Of each set, two of the connectors are used for

the left and right audio channels and the remaining two connectors are parallel stereo

loop-throughs.

The eight rectangular blanks (labeled 1-2, 3-4, 5-6, and 7-8) are used with the

optional Audio Switcher Bussing Kit. The kit contains a printed circuit board with

eight connectors that when installed, is used to daisy-chain three additional

CNX-PAD8As to provide up to a total of 32 room outputs. Refer to the latest

revision of the CNX-ASBK Operations & Installation Guide (Doc. 8143) for further

information.

ROOMS 1 – 8

These eight pair of RCA jacks output the pre-amplified audio to the corresponding

room(s) amplifier(s). Each room output contains left and right audio channels.

4 • Professional Audio Distribution Processor: CNX-PAD8A Operations Guide – DOC. 8174

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Crestron CNX-PAD8 Specifications Page 8