Crestron CP2E Specifications download pdf (Page 14)

2-Series Compact Control System Crestron CP2 & CP2E

Rack Mounting

The CP2 & CP2E can be mounted in a rack or stacked with other equipment. Two

“ears” are provided with the CP2 & CP2E so that the unit can be rack mounted.

These ears must be installed prior to mounting. Complete the following procedure to

attach the ears to the unit. The only tool required is a #2 Phillips screwdriver.

WARNING: To prevent bodily injury when mounting or servicing this unit in a

rack, take special precautions to ensure that the system remains stable. The following

guidelines are provided to ensure your safety:

• When mounting this unit in a partially filled rack, load the rack from the

bottom to the top with the heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack.

NOTE: If rack mounting is not required, rubber feet are provided for tabletop

mounting or stacking. Apply the feet near the corner edges on the underside of the

unit.

NOTE: Reliable earthing of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than direct

connections to the branch circuit. (e.g., use of power strips).

To install the ears:

1. There are screws that secure each side of the CP2 & CP2E top cover. Using

a #2 Phillips screwdriver, remove the three screws closest to the front panel

from one side of the unit. Refer to the diagram following step 3 for a

detailed view.

2. Position a rack ear so that its mounting holes align with the holes vacated

by the screws in step 1.

3. Secure the ear to the unit with three screws from step 1, as shown in the

following diagram.

Ear Attachment for Rack Mounting

USE COVER SCREWS

4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the

opposite side.

Bussing Strip Installation

The 2-Series integrated dual bus control system is supplied with two brass bussing

strips to facilitate commoning (linking) of multiple terminal block connections. The

bussing strips are constructed with four terminal block positions and may be

trimmed to size for various applications or different devices. One strip is supplied for

each 8-position terminal block.

10 • 2-Series Compact Control System: CP2 & CP2E Operations Guide – DOC. 5980A

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Crestron CP2E Specifications Page 14