Crestron iMedia IM-RXV1 Installation Guide download pdf (Page 19)

Crestron IM-RXV1-M & IM-RXV3-M iMedia Receiver with Video & Mic Input

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this

paragraph. Apply power after all connections have been made.

When making connections to the IM-RXV1-M and IM-RXV3-M, consider the

following:

• Use Crestron power supplies for Crestron equipment.

• The included cable cannot be extended.

Hardware Connections (Front, IM-RXV3-M shown)

IM INPUT:

iMEDIA PORT RECEIVERS

AUDIO, VIDEO, AND RGB SIGNALS

AUDIO:

BALANCED OR

UNBALANCED OUTPUT

TO AMPLIFIER

SPEAKER:

AMPLIFIED STEREO

AUDIO OUTPUT

NOTE: For optimum performance, Crestron strongly recommends using

CresCAT-IM cable, available from Crestron. Other high-quality/low skew

CAT5e/CAT6 wiring may also be used with varying performance.

Hardware Connections (Rear)

POWER:

FROM POWER SUPPLY

(18 VDC, 3.0 A)

RELAY OUTPUT:

TWO LOW VOLTAGE

CONTACT CLOSURE

RELAYS

DIGITAL INPUTS:

THREE SCHMIDT

TRIGGER TYPE

IR OUTPUT:

TO IRP2

MIC INPUT:

3.5 mm TRS JACK

BALANCED/UNBALANCED

MONO LINE-LEVEL

COMPUTER:

RJ-11 SERIAL PORT

TO LOAD FILES

OR CONSOLE

LAN:

10/100 BASE-T

ETHERNET TO LAN

COM:

BI-DIRECTIONAL RS-232 WITH

HARDWARE AND SOFTWARE

HANDSHAKING AND MODEM CONTROL

COMPOSITE VIDEO OUTPUT:

TO DISPLAY DEVICE

RGB OUTPUT:

TO DISPLAY DEVICE

NOTE: The power supply cable is equipped with a snap lock connector. Always

disconnect the power cable by pulling back on the snap lock of the connector. Never

pull the power cable by the cord.

NOTE: Ensure that the unit is properly grounded.

Operations & Installation Guide – DOC. 6593A iMedia Receiver: IM-RXV1-M & IM-RXV3-M • 15

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Crestron iMedia IM-RXV1 Installation Guide Page 19

Comments to this Manuals

Related products and manuals for Receiver Crestron iMedia IM-RXV1