Crestron TPMC-8X-BTP Specifications download pdf (Page 16)

Isys i/O

8.4” WiFi Touchpanel Crestron TPMC-8X

Setup

Identity Code

The IP ID is set within the TPMC-8X’s table using Crestron Toolbox™. For

information on setting an IP table, refer to the Crestron Toolbox help file. The IP IDs

of multiple TPMC-8X devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the SIMPL™

Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Internal Battery Switch

The TPMC-8X comes with a TPMC-8X-BTP Internal Battery Pack installed. To

prevent internal battery drain during shipment or long-term storage, the

TPMC-8X has a battery switch inside the battery compartment. To use the internal

battery, remove the battery compartment cover by first removing the two screws that

attach it to the back of the touchpanel. Move the switch to the up (on) position and

re-attach the battery compartment cover.

To conserve internal battery power when the unit will not be used for extended

periods, move the switch to the down (off) position.

NOTE: The internal battery can still be charged with the switch in the off position.

TPMC-8X Internal Battery Switch

12 • Isys i/O

8.4” WiFi Touchpanel: TPMC-8X Operations Guide – DOC. 6539C

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 85 86

No comments

Crestron TPMC-8X-BTP Specifications Page 16