Crestron CT-3000 User Manual download pdf (Page 6)

CRESTRON

2 •• CNX Infrared & Serial Expansion Card: CNXIR-8 Operations Guide - DOC. 8124

Leading Specifications

The table below provides a summary of leading specifications for the CNXIR-8.

Dimensions are approximations rounded to the nearest hundredth unit.

Leading Specifications of the CNXIR-8

SPECIFICATION DETAILS

Power Requirements

24 VDC, network power; 3 Watts

IR Output

Up to 1.12MHz

Output Signal Levels

0 to 5VDC

(compatible with most RS-232 input devices)

SIMPL Windows

Version 1.19.08 or later

CNX Operating System

Version 5.01.00 or later

CNX Monitor

Version 2.00 or later

Dimensions

Height: 0.980 in (2.490 cm)

Width: 5.000 in (12.700 cm)

As of the date of manufacture, the unit has been tested and found to comply with

specifications for CE marking.

Setup

Installation

Items required to install the CNXIR-8 are already attached to the unit. The only

tools required are a Phillips tip screwdriver and a grounding strap. Follow the

assembly procedure below.

CAUTION: The CNXIR-8 contains electrostatic sensitive devices (ESD); observe

precautions for handling ESDs to avoid damaging the card.

NOTE: If installing the CNXIR-8 into a CNMSX-AV, it is assumed that the

CNXCAGE has been installed.

1. Disconnect power from the CNMSX.

2. Use the Phillips tip screwdriver and remove two screws and blank

faceplate from the control system.

3. Align the CNXIR-8 with the card guides in the open slot and slide the

expansion card into postion.

4. Firmly press both ends of the CNXIR-8 faceplate to seat the expansion

card into the control system connector.

5. Tighten the thumb-nail screws to secure the CNXIR-8 to the control

system.

6. Reapply power to the CNMSX.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Crestron CT-3000 User Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown Crestron CT-3000