Crestron TPS-MEM64MB Installation Guide download pdf (Page 20)

Flash Memory Crestron TPS-MEM64MB & TPS-MEM128MB

12. Return the expansion cover plate or TPS-VIDL expansion

card.

CAUTION: If the expansion card is present, the TPS-VIDL connectors

may have to be aligned slightly to fit through the openings in the rear

cover. Align the connectors of this card (or any other optional card that is

installed) carefully to prevent damage to the card, cover, or touchpanel.

13. Install the rear cover by sliding it over any expansion card

connectors that may be present.

14. Re-install the ten cover screws to finger-tight then, using a

#1 Philips screwdriver, tighten the mounting screws an

additional 1/8-turn to secure the cover.

15. Apply power to the unit. If there is no activity, it is likely that

the memory module was improperly replaced. Repeat the

procedure and make sure the jumper for selecting voltage is in

the proper position and that the new module is properly

seated.

16 • Flash Memory for TPS User Interfaces: TPS-MEM64MB & TPS-MEM128MB Installation Guide - DOC. 6261

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Crestron TPS-MEM64MB Installation Guide Page 20