Crestron CNXRY-16 User Manual download pdf (Page 4)

CRESTRON

ground pins are labeled with a C. Two supplied 9-position connectors can be wired

and attached to connectors A and/or B.

Leading Specifications

The table below provides a summary of leading specifications for the CNXRY-16.

Dimensions and weight are approximations rounded to the nearest hundredth unit.

Leading Specifications of the CNXRY-16

SPECIFICATION DETAILS

Power Requirements

24 VDC, network power; 5 Watts

Maximum Rating per Contact

1A, 30 VAC/VDC

SIMPL Windows

Version 1.19.08 or later

CNX Operating System

Version 5.01.00 or later

CNX Monitor

Version 2.00 or later

Dimensions

Height: 0.98 in (2.49 cm)

Width: 5.00 in (12.70 cm)

As of the date of manufacture, the unit has been tested and found to comply with

specifications for CE marking.

Setup

Installation

Items required to install the CNXRY-16 are already attached to the unit. The only

tools required are a Phillips tip screwdriver and a grounding strap. Follow the

assembly procedure below.

CAUTION: The CNXRY-16 contains electrostatic sensitive devices (ESD);

observe precautions for handling ESDs to avoid damaging the card.

NOTE: If installing the CNXRY-16 into a CNMSX-AV, it is assumed that the

CNXCAGE has been installed.

1. Disconnect power from the CNMSX.

2. Use the Phillips tip screwdriver and remove two screws and blank

faceplate from the control system.

3. Align the CNXRY-16 with the card guides in the open slot and slide

the expansion card into position.

4. Firmly press both ends of the CNXRY-16 faceplate to seat the

expansion card into the control system connector.

5. Tighten the thumb-nail screws to secure the CNXRY-16 to the control

system.

6. Reapply power to the CNMSX.

2 • CNX Relay Output Expansion Card: CNXRY-16 Operations Guide - Doc. 8122

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Crestron CNXRY-16 User Manual Page 4

Comments to this Manuals

Related products and manuals for Networking Crestron CNXRY-16