Crestron TPS-ENET Installation Guide download pdf (Page 9)

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel

Touchpanel LAN Port (for reference only)

RGB LANNET/VIDEO 24VDC 2.0A

LINK STATUS

LED (GREEN)

ETHERNET

ACTIVITY

LED (YELLOW)

Industry Compliance

As of the date of manufacture, the TPS-ENET has been tested and found

to comply with specifications for CE marking and standards per EMC

and Radiocommunications Compliance Labelling.

NOTE: This device complies with part 15 of the FCC rules. Operation is

subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Setup

Installation and Hookup

The TPS-ENET is designed to be installed in a specific expansion slot in

the TPS-5000 and TPS-6000 touchpanels. The tools required for

installation are a grounding strap (or grounded workstation) and a #1

Phillips screwdriver.

CAUTION: The TPS-ENET and the touchpanel contain electrostatic

discharge sensitive devices (ESDs); observe precautions for handling

ESDs to avoid damaging the card and/or the touchpanel.

Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Crestron TPS-ENET Installation Guide Page 9