Crestron QM-FBCC/WCC-1 QuickMedia
®
Computer Centers
Operations & Installation Guide – DOC. 6716B QuickMedia
®
: QM-FBCC/WCC-1 27
QM-FBCC/WCC-1 Troubleshooting (Continued)
PWR LED does
not illuminate.
Device is not
receiving power.
Verify Cresnet is
properly attached.
Intermittent or no
audio output.
Verify all cable
connections.
Poor RGB or
video image
quality.
Incorrect peak
and/or boost
setting.
Adjust QM-RMCRX-BA
peak or boost controls
until image quality is
improved. For more
information, refer to the
latest revision of the
QM-RMCRX-BA
Operations Guide
(Doc. 6332).
Loss of
functionality due
to electrostatic
discharge.
Check that all ground
connections have been
made properly.
Check Network Wiring
In order to ensure optimum performance over the full range of your
installation topology, Crestron Certified Wire and only Crestron Certified
Wire may be used. Failure to do so may incur additional charges if
support is required to identify performance deficiencies because of using
improper wire.
CAUTION: Use only Crestron power supplies for Crestron equipment.
Failure to do so could cause equipment damage or void the Crestron
warranty.
CAUTION: Provide sufficient power to the system. Insufficient power
can lead to unpredictable results or damage to the equipment. Please use
the Crestron Power Calculator to help calculate how much power is
needed for the system (www.crestron.com/calculators).
Comments to this Manuals