Crestron ST-CP Specifications download pdf (Page 11)

Crestron ST-1550C 1-Way Wireless RF Touchpanel

Configuring the Touchpanel

Opening Screen for ST-1550C

It may be necessary to make adjustments or configure the touchpanel to

accommodate the preferences of the end user. This is accomplished through the

Preferences And Settings screen. Instructions for configuring the touchpanel are

given in the following paragraphs.

The opening screen, shown to the left of this paragraph, appears when a finger is

held to the touchscreen for about three seconds from the powered down state. This

screen indicates that you are in “setup mode” and can proceed to configure the

touchpanel.

Preferences And Settings

Remove your finger and touch the opening screen again to display the Preferences

And Settings screen, shown to the left of this paragraph. All resources to configure

the touchpanel are available from this menu.

The Preferences And Settings screen displays five buttons: Calibration,

Preferences, Power Management, Advanced Settings, and Return. The Return

button saves all of the setup information to EEPROM and displays the main page

that has been programmed into your system.

Calibration

NOTE: Calibration works best

when performed with a narrow,

blunt instrument (i.e., pencil eraser).

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button’s image. Select the Calibration button to initiate

“calibration mode”. The touchpanel prompts you with a message, “Touch Upper

Left Corner”. Touch the corner of the screen; be as accurate as possible. Another

message, “Touch Lower Right Corner,” appears. Perform the operation to complete

calibration and return to the opening screen.

If the Calibration button from the Preferences and Settings screen cannot be

reached, complete the following steps.

1. Remove power (ST-BTPN, ST-DSN, and/or external AC power pack).

2. Reapply power while holding a finger to the touchscreen for at least three

seconds. During this short period, the words “SETUP MODE” appear. The

opening screen appears when the finger is removed from the touchscreen.

3. Touch the opening screen and select the Calibration button from the

Preferences And Settings screen to enter “calibration mode.”

Preferences Menu

To obtain the Preferences Menu, shown to the left of this paragraph, touch the

Preferences button from the Preferences And Settings screen. Many options for

setting parameters of the touchpanel are available from the Preferences Menu and

are explained in the following paragraphs. After these parameters have been set,

press the Return button to return to the Preferences And Settings screen.

Operations Guide – DOC. 6096A 1-Way Wireless RF Touchpanel: ST-1550C • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments

Crestron ST-CP Specifications Page 11

Comments to this Manuals

Related products and manuals for Processors Crestron ST-CP