Crestron TPMC-8L Installation Guide download pdf (Page 19)

Crestron TPMC-8L Isys i/O™ 8.4” Touchpanel Media Center

“Configure Network Connection” Window

To add a network drive, touch

to browse for the new network connection.

1. Map this connection by selecting a drive letter from the Map Drive Letter

drop box.

2. Enter a User Name and Password.

3. Touch the Remember and reconnect on startup checkbox if so desired.

4. Touch OK to enable the new network connection and return to the

“Network Connections” window.

Once all changes to network connections have been completed, touch OK to return

to the setup menu.

Touch Screen

When Touch Screen is touched, the calibration screen will be displayed. Touch the

screen to begin the calibration process. If the screen is not touched within 10

seconds, the calibration sequence will stop and the screen will again display the

setup menu.

If the screen is touched within the 10-second timeout, it displays a series of messages

indicating that you should touch the red square in five places around the screen.

These messages will appear sequentially starting with “Touch the red square” at the

top of the screen toward the upper left corner. Touch and hold the center of the red

square to initiate calibration. The message will say “Hold…” for a few seconds, then

change to “Lift off to proceed”. Touch the displayed squares as prompted

everywhere they appear around the screen until the calibration is complete and you

are returned to the setup menu.

NOTE: When touching the screen during calibration, be as accurate as possible.

Use the tip of the included stylus. To cancel calibration and return to the setup menu

without saving calibration data, ignore the “Touch the red square” message. After

about 10 seconds, the setup menu will be displayed. If a USB keyboard is attached to

the touchpanel, you can also press the Escape key (Esc) to cancel calibration and

return to the setup menu.

NOTE: The touchpanel’s calibration routine can also be accessed through Crestron

Toolbox if the touchpanel is connected to a control system via TCP/IP. From the

System Info page, select Functions | Setup Mode…. Select Enter Calibration

Mode to begin calibration.

Operations & Installation Guide – DOC. 6594B Isys i/O™ 8.4” Touchpanel Media Center: TPMC-8L • 15

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

No comments

Crestron TPMC-8L Installation Guide Page 19