Crestron DM-RX1-1G Installation Guide download pdf (Page 24)

DigitalMedia™ CAT Receiver Crestron DM-RX1-1G

Rack

Mounting

The DM-RX1-1G can be mounted in a rack with other equipment using

the two mounting holes on either corner of the unit. It is assumed the

required cable has been installed and wiring has been verified.

WARNING: To prevent bodily injury when mounting or servicing this

unit in a rack, take special precautions to ensure that the system remains

stable. The following guidelines are provided to ensure your safety:

• When mounting this unit in a partially filled rack, load the rack

from the bottom to the top with the heaviest component at the

bottom of the rack.

• If the rack is provided with stabilizing devices, install the

stabilizers before mounting or servicing the unit in the rack.

1. Follow steps 1 through 12 in “Installing in a 1-Gang Box”, which

starts on page 14.

2. Attach the unit to the rack using two rack mount screws (not

supplied) as shown in the following illustration.

3. Remove the pre-cut insulation from the grounding wire and

connect it to an appropriate earth ground.

4. Remove the backing from the tape on the back of the included

insert. Affix the insert plate onto the unit as shown. Refer to the

following illustration.

20 • DM

CAT Receiver: DM-RX1-1G Operations & Installation Guide – DOC. 6969B

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

Crestron DM-RX1-1G Installation Guide Page 24