Crestron DIN-8SW8 Installation Guide download pdf (Page 15)

Crestron DIN-8SW8-I DIN Rail High-Voltage Switch

Setup

Network Wiring

When wiring the Cresnet

network, consider the following:

• Use Crestron Certified Wire.

NOTE: Cresnet HP cannot be used

• Use Crestron power supplies for Crestron equipment.

• Provide sufficient power to the system.

CAUTION: Insufficient power can lead to unpredictable results

or damage to the equipment. Please use the Crestron Power

Calculator to help calculate how much power is needed for the

system (

www.crestron.com/calculators).

• For networks with 20 or more devices, use a Cresnet Hub/Repeater

(DIN-HUB) to maintain signal quality.

For more details, refer to “Check Network Wiring” which starts on page

26.

Identity Code

The Net ID of the DIN-8SW8-I has been factory set to 89. The Net IDs

of multiple DIN-8SW8-I devices in the same system must be unique. Net

IDs are changed from the front panel of the DIN-8SW8-I or from a

personal computer (PC) via Crestron Toolbox™ (refer to “Establishing

Communication” on page 21).

To set the Net ID using the front panel:

1. Press the SETUP button to enter the Setup mode. The SETUP

LED illuminates.

2. Press the left button under the NET ID display to change the most

significant digit of the Net ID or press the right button under the

NET ID display to change the least significant digit of the Net ID

number.

Operations & Installation Guide – DOC. 6930A DIN Rail High-Voltage Switch: DIN-8SW8-I • 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

Crestron DIN-8SW8 Installation Guide Page 15