Crestron DIN-8SW8 Installation Guide download pdf (Page 31)

Crestron DIN-8SW8-I DIN Rail High-Voltage Switch

NOTE: All Crestron certified Cresnet wiring must consist of two

twisted pairs. One twisted pair is the +24V conductor and the GND

conductor and the other twisted pair is the Y conductor and the Z

conductor.

Strip and Tin

Wire

When daisy-chaining Cresnet units, strip the ends of the wires carefully

to avoid nicking the conductors. Twist together the ends of the wires that

share a pin on the network connector and tin the twisted connection.

Apply solder only to the ends of the twisted wires. Avoid tinning too far

up the wires or the end becomes brittle. Insert the tinned connection into

the Cresnet connector and tighten the retaining screw. Repeat the

procedure for the other three conductors.

Add Hubs

Use of a Cresnet Hub/Repeater (CNXHUB) is advised whenever the

number of Cresnet devices on a network exceeds 20 or when the

combined total length of Cresnet cable exceeds 914 meters (3000 feet).

Operations & Installation Guide – DOC. 6930A DIN Rail High-Voltage Switch: DIN-8SW8-I • 27

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

No comments

Crestron DIN-8SW8 Installation Guide Page 31