Crestron TPS-IMC Interface Module
Operations Guide - DOC. 5856 Interface Module: TPS-IMC •• 5
NOTE: All network wiring must consist of two twisted-pairs. One twisted pair is the +24V
conductor and the GND conductor and the other twisted pair is the Y conductor and the Z
conductor.
NOTE: When daisy chaining network units, always twist the ends of the incoming wire and
outgoing wire which share a pin on the network connector. After twisting the ends, tin the
twisted connection with solder. Apply solder only to the ends of the twisted wires. Avoid
tinning too far up or the tinned end becomes brittle and breaks. After tinning the twisted ends,
insert the tinned connection into the network connector and tighten the retaining screw.
Repeat the procedure for the other three network conductors.
Hardware Hookup
The TPS-IMC serves as an interface between the touchpanel and the Cresnet system. Refer to
the illustration after this paragraph (which continues on next page) for proper connections;
apply power last. When making network connections to the CNX Generation control system
or Cresnet peripherals, refer to the latest revision of the Cresnet Network Interconnect
Drawing (Doc. 5411). This document can be obtained from the Downloads page (CABLES
and MANUAL Libraries) of the Crestron website (www.crestron.com). Search for
CRESNET.PDF. It is not necessary to make connections to a video source unless the
TPS-VID has been installed into the touchpanel and a video window object resides on a page
within the uploaded VisionTools™ Pro-e project.
NOTE: The positions of the NET/VIDEO and AUDIO ports on early production models
were reversed (compared to the illustration below). Observe the exact screening on the TPS-
IMC before making any connections.
Hardware Hookup for the TPS-IMC
CONNECT
TO DEVICE,
AUDIO INPUT
NOTE:
DO NOT CONFUSE
8-POSITION AUDIO
CABLE WITH
10-POSITION
NET/VIDEO CABLE
CONNECT
TO TPS-5000
OR TPS-6000
CRESTRON
PANEL
TPS - IMC
AUDIO
TO
VIDEO
NET/
CONNECT
TO AUDIO
SOURCE
AUDIO
INPUT
+
S
MIC
OUT
S
L
_
+
_
+
S
R
_
NTSC/PAL VIDEO
CONNECT
TO CNX
GENERATION
CONTROL
SYSTEM
OR CRESNET
PERIPHERALS
NET
Z
G
Y
24
Y
COMP
* CONNECT
TO VIDEO
SOURCE
C
_
+
C
+
_
Y
COMP
S
S
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals