Crestron TPS-IMC User Manual download pdf (Page 8)

Interface Module Crestron TPS-IMC

6 •• Interface Module: TPS-IMC Operations Guide - DOC. 5856

* Connect to a video source only if the TPS-VID expansion card is installed in the touchpanel. The

BNC connector and screw terminal mini Phoenix connector is connected in parallel. Possible options

are no connection, balance video using twisted pair cable, unbalance video using twisted pair cable, or

unbalanced video using coax cable. Depending on the option, the two jumpers on the NTSC/PAL

VIDEO six-pin connector remain attached or are removed.

If there is no video, do not make a connection to this port, but leave connector and jumpers attached to

the NTSC/PAL VIDEO six-pin connector on the TPS-IMC.

Video balance is determined by external connections. Refer to the three diagrams below.

Balanced Using Twisted Pair Cable Unbalanced Using Twisted Pair Cable

JUMPERS

REMOVED.

COMP

NTSC/PAL VIDEO

Y C +

COMP

JUMPERS

REMAIN IN

PLACE.

COMP

NTSC/PAL VIDEO

COMP

Unbalanced Using Coax Cable

JUMPERS

REMAIN IN

PLACE.

COMP

NTSC/PAL VIDEO

COMP

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Crestron TPS-IMC User Manual Page 8