DigitalMedia™ CAT Receiver Crestron DM-RX1-1G
Installation
To prevent overheating, do not operate this product in an area that
exceeds the environmental temperature range listed in the table of
specifications.
To install the DM-RX1-1G, the following tools and accessories are
required:
• DM-CBL DigitalMedia Cable (sold separately.) Refer to “Network
Wiring” on page 13.
• Phillips screwdriver (not supplied)
• Adjustable wrench (not supplied)
• Miniature flat head screwdriver (not supplied)
• Two #06-32 x 3/4" oval head slotted screws (included)
• Decorative style faceplate (not supplied)
• Insert (included)
The DM-RX1-1G can be installed in either a 1-gang electrical box or
rack mounted.
Installing in a
1-Gang Box
An extra-deep box is recommended (2 1/2 inch (64 mm) deep minimum).
It is assumed that the required cable has been fed through an installed
1-gang electrical box (not supplied), and wiring has been verified. Use
the following procedure to install the DM-RX1-1G.
1. Confirm that DMNet system power is OFF.
2. Strip 3 3/4 inches (96 mm) of the DigitalMedia Cable to expose
the three inner cables.
3. Strip the outer jacket of the blue “D” cable 2 1/2 inch (64 mm)
from end. Gather and twist the wire braid. Refer to the illustration
on the following page.
14 • DM
®
CAT Receiver: DM-RX1-1G Operations & Installation Guide – DOC. 6969B
Comments to this Manuals