Crestron TPS-RFGWX Specifications download pdf (Page 10)

Two-Way RF Transceiver Crestron TPS-RFGWX

6 • Two-Way RF Transceiver: TPS-RFGWX Operations Guide - DOC. 5847A

NOTE: Most 6-conductor telephone cables are wired in a crisscross fashion and are

not compatible with Crestron equipment.

NOTE: All NET connectors, the two modular and the four-wire, can be used

simultaneously.

NET (Four-Wire Cresnet)

This 4-pin connector is used to connect the TPS-RFGWX to other four-wire devices

in the Cresnet system.

TPS-RFGWX Indicators

There are five LED indicators located on the front panel of the TPS-RFGWX. Refer

to the diagram and descriptions that begin below. The front panel also has a

connector where the supplied antenna is attached. The antenna transmits and receives

the touchpanel RF signals.

TPS-RFGWX Indicators

RF GATEWAY - 2 WAY

PWR NET RxSIG

TPS-RFGWX

ANTENNA

CRESTRON

PWR

This LED illuminates when Cresnet power is supplied to the TPS-RFGWX.

NET

This LED illuminates when communication with the Cresnet system and the TPS-

RFGWX is established (the unit is polled on the network). Illumination indicates that

the SIMPL Windows program currently loaded has a network device defined at the

same NET ID code as the TPS-RFGWX.

These three LEDs monitor the RF communications of the TPS-RFGWX. The SIG

LED illuminates when the TPS-RFGWX is in RF communication with a touchpanel.

This LED also flashes 20 times to indicate that the TPS-RFGWX has rebooted. The

Rx LED illuminates when a command is received from a touchpanel and Tx

illuminates when feedback is transmitted to a touchpanel. If the touchpanel goes out

of range, the Tx LED will flash every four to five seconds for approximately 30

seconds and then stops flashing (the unit stops transmitting if the touchpanel does not

come into range in the allotted time). If the touchpanel comes into range before the

TPS-RFGWX stops transmitting, the touchpanel display reverts to whatever screen

the control system has active. If the touchpanel comes into range after the TPS-

RFGWX stops transmitting, the user must touch the touchpanel screen to activate the

gateway and leave the out of range screen. Any messages sent to the touchpanel

while it was out of range will be sent after normal communication resumes.

NET

GZY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Crestron TPS-RFGWX Specifications Page 10