Crestron CNX-B4 Installation Guide download pdf (Page 16)

Single Gang Keypads Crestron CNX-B2/B4/B6/B8/B12

12 • Single Gang Keypads: CNX-B2/B4/B6/B8/B12 Operations & Installation Guide - DOC. 8173A

Serial Number to TSID Conversion Tool Window

3. Enter the serial number or TSID number as instructed; press

the appropriate button to obtain the corresponding number.

Installation

The following tools/hardware are required for installation:

• Cresnet network cable (not supplied)

• Phillips screwdriver (not supplied)

• Two 1 in. pan head Phillips screws (supplied)

• Insulation (not supplied)

NOTE: The insulation will protect the sensor from any in-wall

conditions (such as drafts, etc.). Use type in compliance with local codes.

After the Cresnet network wiring has been installed and verified, use the

following procedure to install the keypad in a standard, single-gang

electrical box (refer to illustrations on pages 5 and 6).

1. Turn Cresnet system power OFF.

2. Connect the Cresnet cable with supplied mate to the keypad’s

Cresnet port and the other end to the control system.

3. Insert insulation in electrical box (make sure it fills void of

box not occupied by keypad).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

No comments

Crestron CNX-B4 Installation Guide Page 16