Crestron Adagio ATC-AMFMSR Specifications download pdf (Page 25)

Crestron Adagio™ AES Entertainment System

AES Control Devices

Any combination of six AES control devices such as the APAD or the C2N-DBF12

can be simultaneously connected to the powered NET ports located on the upper-left

side of the rear panel. Refer to the following diagram and “Network Wiring” on page

17 for wiring information when connecting either APAD devices or C2N-DBF12

keypads.

AES with Control Devices

APADAPAD

C2N-DBF12 C2N-DBF12 C2N-DBF12 C2N-DBF12

Fuse Replacement

If the AES does not power up when it is plugged into an AC outlet, the fuse may

need to be replaced. The fuse holder is located on bottom-right of the rear panel

(next to the power cord connector). To replace the fuse:

• Press STANDBY to place the unit in Standby.

• Disconnect power to the AES.

• Use a flat-head screwdriver to push in the fuse holder.

• While pushing in the fuse holder, turn screwdriver counterclockwise until

the fuse holder pops out.

• Remove the fuse from the fuse holder and insert a new fuse.

CAUTION: Only use the specified type of fuse when replacing a blown

fuse. Failure to do so may cause damage to the AES.

Operations Guide – DOC. 6456B Entertainment System: Adagio AES • 21

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

No comments

Crestron Adagio ATC-AMFMSR Specifications Page 25