Crestron CEN-SWPOE-24 Specifications download pdf (Page 10)

16-Port Managed PoE Switch Crestron CEN-SWPOE-16

•

16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B

Setup

Network Wiring

When wiring the Ethernet network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

• Provide sufficient power to the system.

CAUTION: Insufficient power can lead to unpredictable results or damage

to the equipment. Please use the Crestron Power Calculator to help calculate

how much power is needed for the system (

www.crestron.com/calculators).

CAT5 Wiring

Category 5 (CAT5) wiring is a twisted pair cable designed for Ethernet networks.

These networks operate at speeds of up to 1000 megabits per second (Mbps) using

the 1000BASE-T standard. For more information refer to “Appendix: Fast Ethernet

and Gigabit Ethernet” on page 22.

For additional information, refer to the latest version of the Crestron CAT5 Wiring

Reference Guide (Doc. 6137), which is available from the Crestron Web site

(www.crestron.com/manuals

Installation

NOTE: If power needs to be removed from this product, the power cord must be

disconnected; therefore, the socket-outlet must be installed near the equipment and

must be easily accessible.

Ventilation

The CEN-SWPOE-16 should be used in a well-ventilated area. The venting holes

should not be obstructed under any circumstances.

To prevent overheating, do not operate this product in an area that exceeds the

environmental temperature range listed in the table of specifications. Consider using

forced air ventilation and/or incrementing the spacing between units to reduce

overheating. Consideration must be given if installed in a closed or multi-unit rack

assembly since the operating ambient temperature of the environment may be greater

than the room ambient temperature. Contact with thermal insulating materials should

be avoided on all sides of the unit.

NOTE: Installation of the equipment in a rack should be such that the amount of air

flow required for safe operation of the equipment is not compromised.

Rack Mounting

The CEN-SWPOE-16 can be mounted in a rack or stacked with other equipment.

Two “ears” are provided with the CEN-SWPOE-16 so that the unit can be rack

mounted. These ears must be installed prior to mounting. Complete the following

procedure to attach the ears to the unit. The only tool required is a #1 or #2 Phillips

screwdriver.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Crestron CEN-SWPOE-24 Specifications Page 10

Comments to this Manuals

Related products and manuals for Network switches Crestron CEN-SWPOE-24