Crestron CEN-SWPOE-24 Specifications download pdf (Page 22)

16-Port Managed PoE Switch Crestron CEN-SWPOE-16

•

16-Port Managed PoE Switch: CEN-SWPOE-16 Operations Guide – DOC. 7408B

Port Settings

The switch can be set to manually configure the speed and duplex mode used on

specific ports, or can use auto-negotiation to detect the connection settings used by

the attached device. Use the full-duplex mode on ports whenever possible to double

the throughput of switch connections.

To configure the ports on the switch select Port Settings from the navigation menu.

The “Port Settings” screen opens. Refer to the illustration that follows.

“Port Settings” Screen

This screen displays the following information and options:

• Port: Displays port number 1 to 16.

• Link Status: Indicates the link status. A red

indicates that no link is

active. A green

indicates that a link is active.

• Port Enable: Allows enabling or disabling the Ethernet link, which starts or

stops all Ethernet traffic.

• Auto Negotiation: Enables or disables auto negotiation.

• Speed: Selects the speed of the port: 10, 100, or 1000 Mpbs.

• Full Duplex: Check to enable full duplex. Disabling full duplex enables half

duplex operation. Full and half duplex are available for all speeds.

Click Save at the bottom of the page to save changes to these settings. Click Reset to

revert to default settings.

POE Settings

Select POE Settings in the navigation menu to view the the “PoE Settings” screen.

The following columns display information and options for each port on the switch.

Refer to the illustration on the following page.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Crestron CEN-SWPOE-24 Specifications Page 22