Crestron CEN-SWPOE-24 Specifications download pdf (Page 11)

Crestron CEN-SWPOE-16 16-Port Managed PoE Switch

Operations Guide – DOC. 7408B 16-Port Managed PoE Switch: CEN-SWPOE-16

•

WARNING: To prevent bodily injury when mounting or servicing this unit in a

rack, observe the following guidelines:

• When mounting this unit in a partially filled rack, load the rack from the

bottom to the top with the heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack.

NOTE: If rack mounting is not required, rubber feet are provided for tabletop

mounting or stacking. Apply the feet near the corner edges on the underside of the

unit.

NOTE: Reliable earthing of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than direct

connections to the branch circuit (for example, use of power strips).

To install the ears:

1. There are screws that secure each side of the CEN-SWPOE-16 top cover.

Using a #1 or #2 Phillips screwdriver, remove the three screws closest to

the front panel from one side of the unit. Refer to the diagram following

step 3 for a detailed view.

2. Position a rack ear so that its mounting holes align with the holes vacated

by the screws in step 1.

3. Secure the ear to the unit with three screws from step 1, as shown in the

following diagram.

Ear Attachment for Rack Mounting

Use Cover Screws

4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the

opposite side.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Crestron CEN-SWPOE-24 Specifications Page 11