Crestron TPS-3000 Specifications download pdf (Page 14)

Crestron Quick Guide to Touchpanel Connections

Doc. 4903B

RS-232

This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting cable is not

supplied. Use this port to establish a direct connection between the touchpanel and a PC

without a control system or network connection. Once the direct connection is established,

touchpanel files and firmware updates can be uploaded to the touchpanel. Additionally, the

touchpanel diagnostic tools can be accessed over the direct connection.

PIN DESCRIPTION

1 CTS

2 GND

3 RXD

4 TXD

5 RTS

6 N/C (Not connected)

LAN

One 8-wire RJ-45 connector with two LED indicators:

The green LED indicates network speed

The yellow LED indicates Ethernet activity

This connector provides an Ethernet 10baseT/100baseTX, full

duplex, IEEE 802.3U compliant network connection.

PIN SIGNAL PIN SIGNAL

1 TX + 5 N/C

2 TX - 6 RC -

3 RC+ 7 N/C

4 N/C 8 N/C

NET

The four-pin 5 mm detachable terminal

block provides communication with and

power from a Cresnet control network.

Pins 24 and G provide 24 VDC and ground.

Pins Y and Z provide communications (data).

Cresnet® Power Usage

Not including TPMC-CH-IMC (1.0W)

TPMC-12 = 43 W (1.8 A @ 24 V)

TPS-15 = 65 W (2.7 A @ 24 V)

TPS-17 = 74 W (3.08 A @ 24 V)

Crestron recommends an independent power

supply for these touchpanels.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Crestron TPS-3000 Specifications Page 14