Crestron CNX-ASBK Installation Guide download pdf (Page 6)

Audio Switcher Bussing Kit Crestron CNX-ASBK

NOTE: The remaining steps of this procedure describe the installation of one

CNX-ASBK into one CNX-PAD8. The steps apply to all of the CNX-PAD8s to be

daisy-chained and may be performed in an “assembly line” fashion on all of the

CNX-PAD8s at the same time.

7. Place the CNX-PAD8 right-side-up on a flat surface.

8. Remove the cover screws from the top and sides of the CNX-PAD8.

Remove the Cover Screws

REMOVE FOUR

(4) TOP SCREWS

REMOVE THREE

(3) SIDE SCREWS

REMOVE THREE

(3) SIDE SCREWS

IF NOT RACK

MOUNTED, REMOVE

THESE (3) SIDE

SCREWS ALSO

IF NOT RACK

MOUNTED, REMOVE

THESE (3) SIDE

SCREWS ALSO

9. Lift and remove the CNX-PAD8 top cover.

10. From the rear of the CNX-PAD8, remove the 10 back panel cover plate

mounting screws and remove the cover plate.

Back Panel Cover Plate Mounting Screws

ELECTRONICS INC. ROCKLEIGH, N.J. 07647

CRESTRON

RIGHT

LEFT

SOURCES

1 - 2

3 - 4

5 - 6

RIGHT

LEFT

7 - 8

ROOMS

321 7654

Y Z G

CRESNET

24VDC

10 COVER PLATE

MOUNTING SCREWS

11. Making sure that the rear of the PCB assembly faces the rear of the

CNX-PAD8, insert the PCB into the position that was occupied by the

back panel cover plate as shown after this step. Install the PCB with the

10 cover plate screws that were removed.

4 • Audio Switcher Bussing Kit: CNX-ASBK Operations & Installation Guide - DOC. 8143

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Crestron CNX-ASBK Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Processors Crestron CNX-ASBK