Crestron CNX-ASBK Installation Guide download pdf (Page 8)

Audio Switcher Bussing Kit Crestron CNX-ASBK

14. Repeat the previous two steps for all of the remaining PCB to PCB

cables.

15. Install the rack mounting ears and then the remaining cover screws to

11-inch/pounds.

Install the CNX-PAD8 Cover

INSTALL FOUR

(4) TOP SCREWS

INSTALL THREE

(3) SIDE SCREWS

INSTALL THREE

(3) SIDE SCREWS

IF NOT RACK

MOUNTED, INSTALL

THESE (3) SIDE

SCREWS ALSO

IF NOT RACK

MOUNTED, INSTALL

THESE (3) SIDE

SCREWS ALSO

16. If this procedure has been performed on only one CNX-PAD8, repeat

this procedure from step 7 for all of the CNX-PAD8s to be daisy-

chained.

17. If the back panels of the CNX-PAD8s will be accessible when mounted

in the rack, install the CNX-PAD8s. If the back panels will NOT be

accessible, hookup all cables before installing into rack.

NOTE: DO NOT twist the cables during installation. The cables are custom

designed and will fit perfectly. If the cable does not fit correctly, switch the cable

ends from one CNX-PAD8 to another. DO NOT force the connector onto pins.

18. Note the position of the connector keys and install the bussing cables

(6-inch, 12-conductor) from CNX-PAD8 to CNX-PAD8. Shown below

are the bussing cables for audio sources 1 – 2. Connect the cables as

required per custom installation.

Install the Bussing Cables

ELEC S INC. ROCKLEIGH, N.J. 07647

CRESTRON

RIGHT

LEFT

SOURCES

1 - 2

3 - 4

5 - 6

RIGHT

LEFT

7 - 8

ROOMS

321 7654

Y Z G

CRESNET

24VDC

12-PIN, 6-INCH CABLE TO CNX-PAD8

ABOVE, IF APPLICABLE

12-PIN, 6-INCH CABLE TO CNX-PAD8

BELOW, IF APPLICABLE

NOTE POSITION

OF CONNECTOR KEY

6 • Audio Switcher Bussing Kit: CNX-ASBK Operations & Installation Guide - DOC. 8143

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Crestron CNX-ASBK Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Processors Crestron CNX-ASBK