Crestron CNX-ASBK Installation Guide download pdf (Page 9)

Crestron CNX-ASBK Audio Switcher Bussing Kit

19. Daisy-chain the ground wire to each CNX-PAD8.

NOTE: Additional audio patch cords are not required. The bussing cables provide

parallel audio inputs to all of the CNX-PAD8s.

20. Connect the audio RCA cables to the audio inputs and/or audio input

loop-through into their original positions of the original or “primary”

CNX-PAD8.

21. If the configuration of the original CNX-PAD room outputs is to be

kept, reconnect the audio output cables to their original positions.

Connect the audio outputs of the each CNX-PAD8 to their designated

room amplifiers.

22. Connect each 6-pin RJ-11 network device cable to its original position.

23. Using network device cables (not supplied), daisy-chain each

CNX-PAD8 to each other or the control system.

24. At the rear of the CNX-PAD8s, connect the electrical power (4-pin

Cresnet power connectors and/or the external power packs).

Industry Compliance

As of the date of manufacture, this unit has been tested and found to comply with

specifications for CE marking and standards per EMC and Radiocommunications

Compliance Labelling.

Programming Daisy-Chained CNX-PAD8s

The CNX-PAD8s can be programmed to fit any customized installation. Daisy-

chained CNX-PAD8s are programmed individually by using their unique Net IDs.

Refer to the CNX-PAD8 Operations Guide (latest revision of Doc. 8137) for further

information.

Operations & Installation Guide - DOC. 8143 Audio Switcher Bussing Kit: CNX-ASBK • 7

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Crestron CNX-ASBK Installation Guide Page 9