Crestron CN-TVAV Specifications download pdf (Page 17)

Crestron CN-TVAV Programmable TV/AV Controller

Operations Guide - DOC. 5722B Programmable TV/AV Controller: CN-TVAV •• 13

2. From the SIMPL Windows or VT Pro-e menu, select Tools | Viewport

to open the Crestron Viewport.

3. From the Viewport menu, select Functions | Set Network ID. The

software checks the baud rate and then opens the “Set Network ID”

dialog box.

4. In the “Set Network ID” dialog box, select the CN-TVAV from the

Current Network Devices text window.

5. From the Choose the new network ID for the selected device (Hex): text

box, select the new Net ID for the CN-TVAV.

6. Click Set ID to initiate the change. This will display the “ID command

has been sent” dialog box.

7. In the “Command Complete” dialog box, click OK.

8. In the Current Network Devices text window, verify the new NET ID

code.

9. In the “Set Network ID” dialog box, click Close.

NOTE: The new NET ID code may also be verified by selecting Diagnostic |

Report Network Devices in the Viewport.

10. Repeat this procedure for each CN-TVAV to be added to the Cresnet

system.

Loading Crestron Control Software

Crestron control software is available in an electronic form; CD-ROM, email, or

from Crestron’s website. Regardless of how and from where the software is

obtained, this section provides the necessary installation steps. Before performing the

procedures in this section, refer to “Cable Configuration for Programming” on

page 8 for cabling instructions.

Installing Crestron Development Tools

Crestron provides software tools for programming the CN-TVAV. Even if only the

control software is being loaded into the hardware and there are no plans to do any

programming, some Crestron development software must be installed on the PC.

Currently, Crestron programming is accomplished with the use of the following

development tools listed in the table shown on the next page.

NOTE: If the intent is to load software developed elsewhere, install SIMPL

Windows only. To program the CN-TVAV, install all three applications.

NOTE: The latest versions of these applications are available from Crestron’s

website (www.crestron.com). Crestron ControlCD also contains a version (which

may not be as current as the website version). To obtain a free copy of the CD-ROM,

contact Crestron at 1-888-CRESTRON [1-888-273-7876]. Alternatively, complete a

literature request from the Crestron website to obtain one.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Crestron CN-TVAV Specifications Page 17