Crestron CNX-B4 Installation Guide download pdf (Page 26)

Single Gang Keypads Crestron CNX-B2/B4/B6/B8/B12

22 • Single Gang Keypads: CNX-B2/B4/B6/B8/B12 Operations & Installation Guide - DOC. 8173A

These files can be stored into and programmed for use in the keypad

directly or may be edited with the Sound Recorder. For example, the

individual files can be combined to create custom messages.

To play WAV files, a CNX-B12 project must be created in VT Pro-e

(with the WAV files and correct join numbers as part of the project).

NOTE: If you need to create WAV files, refer to Windows Help (Using

Sound Recorder).

NOTE: The following are acceptable file extensions for WAV file

programs developed for the keypads:

.vtp projectname.vtp (source file)

.hex projectname.hex (compiled file)

NOTE: Join numbers assigned to a WAV file in VT Pro-e begin at 20

because join numbers below 20 are already assigned to other keypad

buttons or functions.

NOTE: When you begin to create a new keypad program, note that you

cannot assign pages or sub pages (because keypads have no screen).

Instead, use Tools | Sound Manager from the VT Pro-e menu bar to

create the program and assign joins to the WAV files, etc.

Once the project is created, use File | Upload Project from the VT Pro-e

main menu to load it in the CNX-B12. For more information, refer to the

VT Pro-e help file.

NOTE: This can be done after an identity code (NET ID) is assigned to

the keypad (page 8) or after installation (page 12).

Uploading and Upgrading

Assuming a PC is properly connected to the entire system, Crestron

programming software allows the programmer to upload programs and

projects to the system and touchpanel and/or keypads after their

development. However, there are times when the files for the program

and projects are compiled and not uploaded. Instead, compiled files may

be distributed from programmers to installers, from Crestron to dealers,

etc. Even firmware upgrades are available from the Crestron website as

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

No comments

Crestron CNX-B4 Installation Guide Page 26