Crestron C2N-DAP8RC Specifications download pdf (Page 49)

Crestron C2N-DAP8RC Digital Audio Processor with Room Control

Operations Guide – DOC. 8187A Digital Audio Processor with Room Control: C2N-DAP8RC • 45

a preset button (1 through 5), make adjustments, and press SAVE to store the

settings. To recall a preset, select the preset button; the stored settings are applied.

Audio Switching

Select the AUDIO SWITCH button to display the AUDIO SWITCHING window

used to select the analog audio source you wish to appear on the three possible

outputs.

AUDIO SWITCHING Window

This window lets you select the analog audio source that will appear on the CAT5,

OUTPUT A, and OUTPUT B audio output connectors. You can also choose to mute

the signal to those outputs.

The OUTPUT B CONTROLS section affects only the signals to OUTPUT B. The

BASS, TREBLE, and BALANCE controls are initially set to their middle positions;

the VOLUME control is set to its zero position.

The three buttons at the bottom provide both electronic and relay mute control of all

outputs, and a standard ‘loudness’ selection that provides emphasized treble and

bass. The electronic mute reduces the level of the output to –80 dB (effectively

silent); the relay mute opens the output circuits.

Video Switching

Select the VIDEO SWITCH button to display the VIDEO SWITCHING window to

specify the video output channel.

This screen lets you select any video source and route it to any video destination.

Choices range from routing the inputs from individual sources to individual

destinations through routing one source to all destinations. The VIDEO SENSE

indicators are lit if a video source is detected on VIDEO IN 5 through 16 connectors.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 79 80

No comments

Crestron C2N-DAP8RC Specifications Page 49