Crestron C2ENET-2 Specifications download pdf (Page 23)

Crestron DGE-2 Digital Graphics Engine

IP ID

The IP ID is set within the DGE-2’s IP table using Crestron Toolbox. For

information on setting an IP table, refer to the Crestron Toolbox help file. The IP IDs

of multiple DGE-2 devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the SIMPL

Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Configuring the Touch Screen

NOTE: The only connection required to configure the touch screen is power,

supplied from the DGE-2. Refer to “Hardware Hookup” which starts on page 48 for

details.

The DGE-2 and V-Panel are configured from the setup menu.

NOTE: If no project has been loaded or if an invalid project has been loaded, the

touch screen displays an error message and defaults to the setup menu screen.

If a project is running, the setup menu can be accessed using one of three methods:

1. Touch the screen during boot up when the “Preparing to Load Project”

message is displayed. Maintain touch until after the countdown, when the

message changes to “Loading Setup Screen”.

2. If the project has a button defined for this purpose, touching the button

provides entry into the setup menu.

3. Crestron Toolbox can be also used to enter the setup menu:

a. Establish communication with the touch screen (refer to “Establishing

Communication” on page 61 for details).

b. Right-click on the device and select Functions | Setup Mode….

“Setup/Calibrate” Window

c. Select Enter Setup Mode. The setup menu is displayed as shown in

the following illustration.

Operations Guide – DOC. 6809E Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 • 19

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

No comments

Crestron C2ENET-2 Specifications Page 23