Crestron C2ENET-2 Specifications download pdf (Page 29)

Crestron DGE-2 Digital Graphics Engine

initiate calibration. As each new crosshair is touched, the next appears. After the

upper left, crosshairs appears in the upper center, upper right, middle left, screen

center, middle right, lower left, lower center and finally lower right. Touch the center

of the crosshair in the lower right of the screen to conclude calibration and return to

the “Touch Screen Settings” window. Touch OK to accept the changes and return to

the setup menu.

NOTE: When touching the screen during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and

return to the “Touch Screen Settings” window without saving calibration data, create

a calibration error by touching the screen in the same spot for each calibration point.

NOTE: The touch screen’s calibration routine can also be accessed through Crestron

Toolbox if the touch screen is connected to a control system via Cresnet and/or

TCP/IP by selecting the device from the Network Device Tree and right-clicking the

device to select Functions | Setup Mode…. Select Enter Calibration Mode to

begin calibration.

When Touch Screen Test is touched, the test screen is displayed (refer to illustration

below). This screen allows the user to test the touch screen response at 17 points on

the screen. Each button on the screen lights when touched. Touch Return to exit the

test screen.

Touch Screen Test Window

Operations Guide – DOC. 6809E Digital Graphics Engine with DigitalMedia™ CAT Connectivity: DGE-2 • 25

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

No comments

Crestron C2ENET-2 Specifications Page 29