Crestron CN-TVAV Specifications download pdf (Page 36)

Programmable TV/AV Controller Crestron CN-TVAV

32 •• Programmable TV/AV Controller: CN-TVAV Operations Guide - DOC. 5722B

6. From the front panel, the fuse assembly is located at the left-rear corner

of the CN-TVAV. As shown below, remove fuse by pulling top of fuse

straight up.

Remove Fuse

NOTE: If a resistance checker is available, verify that fuse is open/maximum

resistance. If fuse is good/no resistance, contact Crestron customer service. If fuse is

verified open, continue to the next step.

7. Refer to “Leading Specifications” that begins on page 6 and replace

fuse with same type and rating. As shown below, align the fuse and

fuse base pins and install.

Install Replacement Fuse

8. Slide the cover from the rear of the CN-TVAV forward.

9. Turn the CN-TVAV over to bottom-side up.

NOTE: The inner-most screw holes of the cover and CN-TVAV are machined for

unit rack mounting and do not accommodate the cover screws. Do not install the

cover screws into the inner-most screw holes.

10. Install the four cover screws that were removed in step 3 into the

outer-most screw holes and tighten to finger-tight, then using a #1

Phillips screwdriver, tighten an additional 1/8-turn.

11. Turn the CN-TVAV over to top-side up.

NOTE: If the cables were labeled and disconnected from the rear panel ports of the

CN-TVAV, reconnect each cable.

12. Connect the POWER IN plug to the power source.

1 2 ... 31 32 33 34 35 36 37 38 39 40

No comments

Crestron CN-TVAV Specifications Page 36