Crestron TPS-1700 Specifications download pdf (Page 10)

Isys

™

Wired 5.7 Inch Tabletop Touchpanel Crestron TPS-1700

6 • Isys

™

Wired 5.7 Inch Tabletop Touchpanel: TPS-1700 Operations Guide - DOC. 6117

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to

avoid nicking the conductors. Twist together the ends of the wires that share a pin on

the network connector, and tin the twisted connection. Apply solder only to the ends

of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.

Insert the tinned connection into the Cresnet connector and tighten the retaining

screw. Repeat the procedure for the other three conductors.

NOTE: For larger networks (i.e., greater than 28 network devices), it may be

necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality

throughout the network. Also, for networks with lengthy cable runs, it may be

desirable to add a hub/repeater after only 20 network devices.

Identity Code

Every equipment and user interface within the Cresnet system requires a unique

Cresnet identity code (NET ID). These codes are two-digit hexadecimal numbers

from 03 to FE. Refer to “Select Interface” on page 7 for instructions on setting the

unit’s NET ID. The NET ID of the unit must match the NET ID specified in the

SIMPL Windows program. Refer to “Setting the Net ID in Device Settings” on page

12 for details of the SIMPL Windows procedure.

Configuring the Touchpanel

NOTE: The only connection required to configure the touchpanel is power. Refer to

“Hardware Hookup” on page 9 for details.

MAIN MENU

This menu can also be obtained via

digital reserved join number, 17242.

To configure the unit, it may be necessary to access a series of setup screens prior to

viewing run-time screens that are loaded into the touchpanel for normal operation.

The MAIN MENU for configuring the touchpanel appears when a finger is held

(approx. 5 seconds) to the touchscreen when power is applied.

Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four

buttons: Touch Screen Calibration, Exit and Run Program, Setup, and

Diagnostics.

Selecting Exit and Run Program verifies that all of the setup information has been

saved to EEPROM and displays the main page that has been programmed into the

touchpanel. The remaining buttons on the MAIN MENU open other menus, which

are discussed in subsequent paragraphs.

Calibration Menu

CALIBRATION MENU

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button's image. Select the Touch Screen Calibration

utton to

display the CALIBRATION MENU, as shown to the left. The CALIBRATION

MENU offers the choice to initiate calibration with the Perform Calibration button

or return to the previous screen with the Return button. Choose an option by

touching the appropriate button.

If you need to calibrate the touchpanel, the screen displays the message "Touch

Upper Left" centered on the panel with a cross hair in the upper left corner. Touch

the cross hair to initiate calibration. Another message, "Touch Upper Right", appears

with a cross hair in the correct corner. Touch the cross hair. A final message, “Touch

Lower Right”, appears with a cross hair in the correct corner. Touch the crosshair to

finish the calibration and return to the MAIN MENU.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Crestron TPS-1700 Specifications Page 10

Comments to this Manuals

Related products and manuals for Unknown Crestron TPS-1700