Crestron TPS-1700 Specifications download pdf (Page 31)

Crestron TPS-1700 Isys

™

Wired 5.7 Inch Tabletop Touchpanel

Operations Guide - DOC. 6117 Isys

™

Wired 5.7 Inch Tabletop Touchpanel: TPS-1700 • 27

Appendix: Engraveable Pushbutton Installation

Perform the following to install engraveable pushbuttons on the TPS-1700.

A #1 Phillips screwdriver is required. Refer to the illustration below.

NOTE: Use the Crestron Engraver software to submit an Engraver file. The

Engraving Software package, version 1.1.1.6, is available from the Downloads |

Software Updates section of the Crestron website (www.crestron.com

1. Place the touchpanel face down on a clean work surface.

2. Remove the four screws securing the front bezel to the base, and return the

unit to its normal position (use care to prevent the bezel from dropping and

becoming damaged).

3. Lift the bezel from the touchpanel, and remove the pushbuttons being

replaced. Note that the pushbutton sets fit snugly.

4. Put the new pushbuttons in place (see following Note), press firmly to

ensure they are seated, and place the bezel back in position.

NOTE: The rear of the pushbuttons are marked TOP 1-5 and 6-10 to ensure correct

orientation when installed. Do not separate buttons from their plastic framing.

NOTE: The pushbutton sets are not interchangeable with each other

5. Hold the bezel in place and turn the unit over on its face.

6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,

being careful not to strip the threads.

7. Verify that the pushbuttons function properly.

Engraveable Pushbutton Installation

ScrewScrew

Bezel

Pushbuttons

Bottom view

Top view with

bezel removed

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

No comments

Crestron TPS-1700 Specifications Page 31