Crestron TPS-1700 Specifications download pdf (Page 11)

Crestron TPS-1700 Isys

™

Wired 5.7 Inch Tabletop Touchpanel

Operations Guide - DOC. 6117 Isys

™

Wired 5.7 Inch Tabletop Touchpanel: TPS-1700 • 7

NOTE: When touching each crosshair during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and

return to the CALIBRATION MENU without saving calibration data, create a

calibration error by touching the screen in an area that is opposite from the instructed

area.

Setup Menu

SETUP MENU

To obtain the SETUP MENU, shown to the left, press the Setup button from the

MAIN MENU. The SETUP MENU offers a series of buttons, which open additional

menus and screens that are detailed in subsequent paragraphs. After setup parameters

have been set, select the Return button to return to the MAIN MENU.

NOTE: For convenience, the current CRESNET ID setting is displayed in the lower

left corner.

NOTE: All touchpanel settings are automatically saved in non-volatile memory.

Select Interface

SELECT INTERFACE

The touchpanel communicates with a control system to activate commands or to

display feedback from components within the system. The communication interface

must be correctly specified or communication will not occur. To set communication

parameters, first select the Interface button on the SETUP MENU to display the

SELECT INTERFACE screen, shown to the left. Then, select the CRESNET button

to display the CRESNET INTERFACE MENU. Use that screen to set the Cresnet

network identity (CRESNET ID).

After the Cresnet ID setting has been verified, touch the Return button at the bottom

of the screen to save the setting and display the SELECT INTERFACE menu.

KEY CLICK SETUP

Key Click Setup

From the SETUP MENU, press the Key Click Enabled button to open KEY CLICK

SETUP screen. (If the function is currently disabled, the button legend is “Ke

Click

Disabled.”) To enable an audible tone (beep) when the touchpanel buttons are

pressed, select among the Short, Med, or Long KEY CLICK ENABLE/LEN

uttons to set the duration of the tone. The touchpanel responds with a corresponding

signal. To disable the feature, select Click Off.

Use the KEY CLICK VOLUME UP and DOWN buttons to increase and decrease

the volume of the signal. The area to the right of the buttons shows the relative

volume from 0% to 100%, both as a numeric value and, for a quick visual reference,

as an analog bar.

Select the Return button to return to the SETUP MENU.

SCREEN SETTINGS -

BRIGHTNESS

Brightness

From the SETUP MENU, press the Brightness button to open the SCREEN

SETTINGS – BRIGHTNESS screen. The UP and DOWN buttons increase and

decrease screen brightness, respectively. The area to the right of the buttons shows

the relative brightness from 0% to 100%.

Select the Return button to return to the SETUP MENU.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Crestron TPS-1700 Specifications Page 11

Comments to this Manuals

Related products and manuals for Unknown Crestron TPS-1700